Try the layout with four blocks
Lay four finished blocks on a table in two rows of two, all with their black points at the upper right. Now give the upper-right block and the lower-left block a half-turn. Their points should face the lower left. Step back and look at the warm prints between the black lines. Those four blocks show the repeat you’ll carry across the whole top.
For the twin quilt pictured, lay out seven blocks across and ten down. A quick way to check the layout is to look only at the first point in each row. It should face upper right in the first row, lower left in the second, and continue alternating to the bottom. Take a photo before gathering the rows for sewing.
Choose your finished quilt size
| Size |
Blocks across × down |
Finished quilt |
| Baby |
3 × 4 |
38″ × 46″ |
| Throw |
5 × 6 |
54″ × 62″ |
| Twin |
7 × 10 |
70″ × 94″ |
| Queen |
10 × 11 |
94″ × 102″ |
| King |
11 × 12 |
102″ × 110″ |
Each size has the same three borders. A narrow ivory strip gives the outermost black points a little breathing room. A second, black strip outlines the patchwork before the wider outer border goes on. To audition that last fabric, fold it into a five-inch band and lay it alongside several blocks. That’s how much of its color and print you’ll see in the finished quilt.
Download the free illustrated quilt guide
Keep the block diagram beside your machine and save the full layout for your design wall. The printable guide includes fabric quantities for all five sizes, cutting measurements, color diagrams, border lengths, and binding instructions.
Before you sew the rows together, look for places where two neighboring blocks bring the same print up against a black flash. Two tomato-red rectangles on either side of a point can look like a single ribbon with a bend in it. If you like that effect, repeat it in a few spots across the top. To try a different pairing, swap two blocks that already face the same direction.
When you’re ready to join the blocks, clip a numbered scrap of paper to the left edge of the first block in each row. Keep the clip there until that row is sewn. It marks both the row number and the end that belongs on the left, which is handy when you carry a long strip of patchwork from the ironing board back to the machine.
Download the free illustrated quilt guide
Before attaching the borders, spread the pieced top on a flat surface and measure its length through the center. Cut both side borders to that measurement and pin the ends and midpoints first. After sewing the sides, measure across the center again for the top and bottom strips. Repeat this process for each border, especially the narrow ivory one, where a ripple will show against the black.
Save a few black, ivory, and printed scraps to make a small quilting sample. Try a warm gray thread across all three fabrics, then quilt a second line in the gold or raspberry you used in the blocks. Look at the stitches where they cross the black rail. That little stretch will tell you which thread lets the pieced staircase catch your eye first and which one gives the quilting a stronger voice.